Error pushing the netcfg to the controller

[URIB4u]

Hello,

I was trying to push a netcfg file on to my onos controller using the NG-SDN tutorial, I have two onos controllers in the network thus, the little change in the netcfg name. but whenever I call the 'make netcfg' it resulted in the error as shown on the pic below.

But when I checked the configuration file from the browser, it shows that the config has been pushed.

so I tried to go ahead, since I can see the netcfg in the controller, I built the app and tried installing it. which resulted in a similar error as shown below.

the curl is not working and I have no idea how to fix it.

please I need help how to work around it, thanks

Usman

[URIB4u]

Hello @Dscano please any idea on how to fix this?

[Dscano]

Hi,

• Are you running ONOS within some container?
• you can push the netcfg also via ONOS REST API, there should be at network config call
• Whne you push the netcfg the devices are discovered? What you see in the ONOS logs?

[URIB4u]

Hi,

• Are you running ONOS within some container?
• you can push the netcfg also via ONOS REST API, there should be at network config call
• Whne you push the netcfg the devices are discovered? What you see in the ONOS logs?

Thanks for your response.
yes I have a topology with multiple onos controllers running as docker containers, for the containers I did port mapping 6612:8181 and 8112:8101 then 6634:8181 and 8134:8101 I can access the controllers GUI but couldn't see any of the devices.

After I tried pushing the netcfg the devices are not showing in the controller despite that I can see the config as in the above screenshot 2.

Regards

[Dscano]

I think that you are not exposing the port 80 as you can see in the error messages, try to run just one ONOS docker withe the flag --network host (you have to remove the por mapping) i belive that in this way you will be able to push the configuration and see the devices. After that try to use the 2 controller but pay attention to port mapping

[URIB4u]

I think that you are not exposing the port 80 as you can see in the error messages, try to run just one ONOS docker withe the flag --network host (you have to remove the por mapping) i belive that in this way you will be able to push the configuration and see the devices. After that try to use the 2 controller but pay attention to port mapping

Hi,
Sorry for the late reply, some other things took me away.
i disabled the other controllers and added a port mapping 80:80 but still the curl timeout, the devices are not shown despite if I use URL of the config I can see it through the browser.